Shutdown
========

Cameras
-------

The camera controller does not automatically shut the cameras down,
so please be kind and shut them down manually 😇


On the :term:`Camera Controller`:

.. raw:: latex

  \begingroup
  \begin{minipage}{\textwidth}


#. Press the ``SYSTEM`` button to show the system page (see :numref:`cc-sys-1`)
#. Turn the ``F1`` knob shown in :numref:`cc-sys-2` until the text under "CAM POWER" says "ALL OFF" (in yellow)
#. Press down ⬇️ on the F1 knob (it's a button too)

  * The text should go back to “NON” (whatever that means) and no longer be yellow
  * The indicators for the cameras (below the screen and its knobs)
    should go from green to amber (aka “orange”) as shown in :numref:`cc-sys-3`


.. raw:: latex

  \end{minipage}
  \endgroup


.. subfigure:: A
  :name: cc-sys-1

  .. image:: images/CC-System-1.jpg
    :width: 50%

  System Button

.. subfigure:: A
  :name: cc-sys-2

  .. image:: images/CC-System-2.jpg
    :width: 50%

  F1 Knob

.. subfigure:: A
  :name: cc-sys-3

  .. image:: images/CC-System-3.jpg
    :width: 50%

  Final Result


.. .. subfigure:: AB|C.
..     :name: cc-system
..     :layout-sm: A|B|C
..     :gap: 1em
..     :subcaptions: below
..     :align: center

..     .. image:: images/CC-System-1.jpg
..         :alt: Step 1

..     .. image:: images/CC-System-2.jpg
..         :alt: Steps 2 and 3

..     .. image:: images/CC-System-3.jpg
..         :alt: Afterwards

..     Camera System Page


🫡  Thank you for that! 🏆


Controllers
-----------

#. Turn off the :term:`Camera Controller` using the switch on the back left side (after shutting down the cameras, of course).
   See :numref:`cc-power` for details.
#. Slightly unplug the network connector on the back of the :term:`Switcher Controller` (since there's no power switch 😒).

    * This should be the one on the right (see :numref:`switcher-power` for details).

#. If you don't mind, please also turn off the video monitors since they won't do it automatically.


Rack
----

.. caution::

  🚨 Before doing this, make sure all recordings / streams have been stopped! 🚨

  All steps from the :ref:`record-stop` section should have been followed at this point.

  The :term:`HyperDecks <Hyperdeck>` in the rack should not have anything lit up except the stop ⏹️ buttons.
  Data loss is likely if they're still writing to their SD cards!



* In the :term:`Wall Rack`, turn off the switch on the :term:`Power Conditioner` (see :numref:`rack-power`)


🎊 That's it, congratulations!  You can finally go home 😎