.. raw:: latex \pagebreak[4] .. _after-meeting: After the Meeting ================= Audio ----- In the ``Mic Controls`` page of the :term:`Touch Panel`, make sure all of the audio sources are muted (Mute buttons should be red). .. _record-stop: Recorders / Stream ------------------ * In the :term:`CivicClerk` Event Page: * Set the "Meeting End Time" to the current time * |ico-CP-End-Time| * Click the |ico-CP-End-Live| button * You should see a popup saying that the video is being processed. You can close the page after this. * In the :term:`Wall Rack`, find the two :term:`HyperDecks ` and the :term:`Live Encoder`: * Press the ``Stop`` ⏹️ button on both :term:`HyperDecks ` * On the :term:`Live Encoder`, press the blue streaming button to stop the stream. It should now be white. .. |ico-CP-End-Time| image:: images/CP-End-Time.jpg :alt: Meeting End Time :class: no-scaled-link :height: 10ex .. |ico-CP-End-Live| image:: images/CP-End-Live-Button.jpg :alt: End Live Button :class: no-scaled-link :height: 3ex .. _video-route-post: Routing ------- The main video feed needs to be switched back to the :term:`Off Air` feed. This is so we always have a pretty picture going to our cable channel. Once again, we'll do this on the :term:`VideoHub` located in the :term:`Wall Rack`. .. note:: Before doing this, make sure all recordings and streams have been stopped .. raw:: latex \begingroup \begin{minipage}{\textwidth} On the :term:`VideoHub`: 1. Press ``DEST`` then ``3`` - Both ``DEST`` and ``3`` should be lit - The labels on the display should say “ATEM PGM” on the bottom-left and “PGM” on the bottom-right 2. Press ``SRC`` then ``9`` - Both ``SRC`` and ``9`` should be lit and the ``CLEAR`` and ``TAKE`` buttons should be flashing - The labels on the display should say “Brightsign” (bottom-left) and “PGM” (bottom-right) 3. Press ``TAKE`` - The buttons should all be off and the labels should still say “Brightsign” and “PGM” .. raw:: latex \end{minipage} \endgroup